Configuration Requirements
Road Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station
Installation Manual Witty Park 2
Configuration device: laptop
Follow the steps
Step 1: Hold the RFID tag in front of the RFID reader for at least 7 seconds to activate the Wi-Fi hotspot. A blue LED light will indicate that the hotspot has been activated successfully.
Step 2: Connect your laptop to the Wi-Fi network that has the serial number of the charger as the SSID: Witty-xxxxxx (the last 6 digits of the serial number).
Step 3: Open your web browser and enter the IP address or computer host name of the charger in the search bar:
IP address: 192.168.3.5
Computer host name: Hager.local
Step 4: Enter the login credentials that are shown on the label on the side of the charger.
Username: admin
Password: the first 4 digits of the serial number
Step 5: Open the Charging station tab, select Network and configure the preferred connection method.
Note: If a Road SIM card is used, go to the network settings and activate the mobile data connection. Here you can enter the following APN to activate the connection:
When using a white Road SIM card or another connection method:
m2m.servicesWhen using a purple Road SIM card:
road.io
Step 6: Open the Access management tab, select Access methods and enable Controlled access.
Step 7: Select Charging point operator and enter the following values:
Charging point operator address:
When using a white Road sim card or another connection method ws://ocpp.road.io/<provider-slug>
When using a purple Road sim card ws://ocpp-internal.road.io/<provider-slug>
OCPP ID: Enter the serial number of the charger
Authentication type: Basic
Password: Not required
