Configuration Requirements
EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station.
GO-eCharger reset card.
Go-e mobile app.
Online installation & user guide Go-eCharger.
Mobile phone.
Follow the steps:
Step 1: Connect your device to your charge point
Begin the process by connecting your phone to the charge point. Please note that some devices require you to switch off mobile data and disconnect from any WiFi networks for this to work.
There are two ways to connect to the charge point:
a. Find a hidden QR code and the serial number of your charger. Scan the QR code.
b. Search for the charge point's hotspot manually (in the settings of the device, search for the hotspot that the charge point is emitting; the details are on the reset card).
Hotspot name is "Hotspot SSID" (go-e-######).
Hotspot password is "Hotspot key" (##########).
Step 2: Open the go-e app
If you can see the charge point in the app, proceed to configure it.
If you do not see your charge point, add it in the app by using the preferred option, as shown below.
Step 3: Connect the charge point to your local WiFi
In the bottom of the screen, select the Internet tab.
Then, select the WiFi bar and connect the charge point to your local WiFi.
Step 4: Configure the OCPP settings
Open the Internet tab and go to OCPP.
Enable OCPP 1.6 with the toggle.
Change the OCPP Server URL to: ws://ocpp.road.io/<provider-slug>/goe######
The numbers (#) are the same as the ones in Hotspot SSID.
Step 5: Reboot the charge point
Click on the Internet tab again and click on Reboot.