Configuration Requirements
Road Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station
Laptop equipped with a Windows operating system
UTP cable (RJ45)
Follow the steps:
Step 1: connect the laptop to the chargingstation with the UTP cable by connecting the cable on the Ethernet port on the left side of the motherboard.
Step 2: Go to the Network settings on your laptop. Select Change adapter settings.
Step 3: Right mouse click on the ethernet connection and select Properties
Step 4: Double click on Protocol version 4 (TCP/IPv4)
Step 5: Change the network settings as listed in the screenshot below and click OK to proceed.
Step 6: Open your browser and enter the following URL: http://192.168.10.42:12800/admin/admin.html you will now enter the chargepoint homepage.
Step 7: Fill in the following information:
ChargePointID: Serialnumber of the charger or EVSE-id as on the sticker from Road.
ChargepointModel: Type of charging station
ChargeBoxSerialNumber: Box Serial of the chargestation (view grey sticker on the chargestation)
ChargepointVendor: eNovates
Step 8: Fill in the OCPP settings
OCPP type: OCPP 1.6
Endpoint: Other
Endpoint URL:
When using a white Road SIM card or another connection method:
ws://ocpp.road.io/<provider-slug>When using a purple Road SIM card:
ws://ocpp-internal.road.io/<provider-slug>
If you want to connect the charger to the Road backoffice with a simcard proceed to step 9, if you want to connect using a Ethernet cable proceed to step 10
Step 9: Click on Network settings. Fill in the following:
Preset: Simcard
Type: Modem
APN:
When using a white Road SIM card or another connection method:
m2m.servicesWhen using a purple Road SIM card:
road.io
Username: *Leave empty*
Password: *Leave empty*
Press Apply and restart the charger
Step 10: Click on Network settings and fill in the following settings:
Steps to take with a charging station wich is able to set up his own IP-address:
Preset: Ethernet DHCP connection
Type: eth0 dhcp
ETH0 DHCP: No additional settings
Steps to take with a charging station wich is not able to set up his own IP-address
Type: eth0 static
Change the settings as shown below
Press Apply and restart the charger
Step 11: Go to BackendLink Status. Here you can check if the charger is connected to the Road backoffice. You can see this if the status says Online=true.
The charging station is now connected to the Road platform!