Configuration Requirements
Road Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station
Green Motion DC Installation guide
Configuration device: laptop
Ethernet cable
Follow the steps
Note: The Green Motion DC EV charger can be configured via a web portal using the configuration page. The web portal is accessible from a laptop, connected via Ethernet to the internal Teltonika RUTX09 modem/router. The web portal is supported by Chrome, Opera, and Firefox web browsers. It is not supported by the Safari browser.
Step 1: Turn the EV charger off using the circuit breaker and connect a laptop with an RJ-45 cable to any of the LAN ports of the Teltonika router inside the charger (consult the installation guide for more information).
Step 2: Turn the EV charger on using the circuit breaker and wait for the LED indicator on the EV charger to turn green.
Step 3: Using a web browser, navigate to the address: http://192.168.52.11. You may see a warning message before you get to the configuration page. You can safely ignore this warning and proceed further. Click the “Proceed to 192.168.52.11 (unsafe)” hyperlink (see below) to proceed to the configuration page.
Step 4: Once you’ve proceeded to the give address, you will enter the configuration page as shown in the screenshot below.
Note: When connecting the EV charger via the Ethernet, the configuration session is active for 30 minutes. After 30 minutes, the EV charger must be restarted for the configuration session to be resumed.
Step 5: Navigate to the OCPP configuration section in the configuration page and enter the following values:
Server URL: ws://ocpp.road.io/{provider-slug}/{BoxId}
Security Profile: 2 - TLS user/password authentication
User: ‘Leave empty’
Password: ‘Leave empty’
Step 6: Click “Save” and “Restart App” in the Reboot and Apply section at the bottom of the configuration page.