Configuration Requirements
Road Sim card (optional), EVSE ID, configuration manual for the installer and registration manual for the owner of the charging station.
Mobile phone or laptop.
Peblar quick start guide hard-copy.
Peblar full manual (optional, can be found online).
Follow the steps:
Step 1: Connect your phone or laptop to the hostname of the charger
You can directly scan the QR code on the left side of the commissioning label with your phone, or connect to the hostname (first row on the label) and insert the WLAN password (second row on the label).
The log-in settings are found on the quick start guide located in the packaging of the Peblar charger, located on position (1) shown in the figure below.
Step 2: Go to the Peblar Config page
Go to the config page URL of the Peblar charger in your web browser. This URL is located on the third row of the commissioning label. The laptop or phone should show the screen below.
Step 3: Configure the WLAN settings
Configure the WLAN settings in the web interface by selecting your home network and entering your credentials of this network. A network connection is required to connect the charger to the E-Flux by Road backend.
Step 4: Configure the installation settings
Configure the current limit, connected phases and load balancing based on the electrical installation and press Next afterwards.
Step 5: Connect the charger to the E-Flux back office URL
Select Managed in the authorization tab. Then, select E-Flux from the drop-down menu and change the Backoffice URL to:
When using a white Road SIM card or another connection method:
wss://ocpp.road.io/<provider-slug>Note: Purple road simcard do not work with Peblar charging stations!
Step 6: Finish the configuration
Finish the configuration and reboot the charger.
The charging station is now connected to the Road platform!